Beta firmware channel
This session will install pre-release firmware. Beta builds may be less stable and can change without notice. Return to production firmware.
Serial flashing needs a supported browser
The flasher needs the Web Serial API, available in desktop Chrome, Edge, or Opera. Open this page in one of those on a computer and connect your Biscuit with a data USB cable. Installation guides and verified downloads remain available below.
Before you start
- Power on your Biscuit.
- Plug it into your computer with a data USB cable.
- Choose your model below.
Official Hardware
Kits & DIY
Nodes
Biscuit Pro
…
Two chips, one Biscuit — flash them in any order.
Keep the same USB cable connected. In the browser dialog, select
either serial interface: we detect which chip it is and flash that
half, then prompt you to select the other. The C5 appears as
“USB JTAG/serial debug unit”, the WROOM as
“USB Serial (CP210x/CH340)”.
0%
Working…
First try: leave the Biscuit powered on and click Connect & Flash. No button sequence is normally needed. If it won't connect, hold BOOT, tap RESET, release BOOT, then try again.
What's new in this release
console